Ink Cartridge Safety Instructions - Epson WorkForce WF-7010 Important Safety Instructions Manual

Notices
Hide thumbs Also See for WorkForce WF-7010:
Table of Contents

Advertisement

Available languages

Available languages

Do not move the print head by hand; this may damage the product.
Do not spill liquid on the product or use the product with wet hands.
Do not use aerosol products that contain flammable gases inside or around the product. Doing
so may cause fire.
Except as specifically explained in your documentation, do not attempt to disassemble or
service any part of the product yourself.
Unplug the product and refer servicing to qualified service personnel under the following
conditions: if the power cord or plug is damaged; if liquid has entered the product; if the
product has been dropped or the case damaged; if the product does not operate normally or
exhibits a distinct change in performance. Adjust only those controls that are covered by the
operating instructions.
If damage occurs to the plug, replace the cord set or consult a qualified electrician. If there are
fuses in the plug, make sure you replace them with fuses of the correct size and rating.
Leave the ink cartridges installed. Removing the cartridges can dehydrate the print head and
may prevent the product from printing.
Before transporting the product, make sure that the print head is in the home (far right)
position and the ink cartridges are in place.
When storing or transporting the product, do not tilt it, stand it on its side, or turn it upside
down; otherwise ink may leak from the cartridges.
To avoid adversely affecting the operation of the following equipment and causing an accident,
do not use the product: near medical equipment in a medical facility; within 8.7 inches (22 cm)
of a cardiac pacemaker; near automatically controlled devices, such as automatic doors or fire
alarms.

Ink Cartridge Safety Instructions

Keep ink cartridges out of the reach of children.
Be careful when you handle used ink cartridges; there may be ink remaining around the ink
supply port. If ink gets on your skin, wash it thoroughly with soap and water. If it gets in your
eyes, flush them immediately with water. If ink gets in your mouth, spit it out and see a doctor
right away.
Do not put your hand inside the product or touch any cartridges during printing.
Install a new ink cartridge immediately after removing an expended one. Leaving cartridges
uninstalled can dehydrate the print head and may prevent the product from printing.
Do not remove or tear the label on the cartridge; this can cause leakage.
Do not touch the green IC chip on the side of the cartridge. This may prevent normal
operation.
2
Important Safety Instructions

Advertisement

Table of Contents
loading

This manual is also suitable for:

B511a

Table of Contents