Completing The Configuration - HP BL680c - ProLiant - G5 Installation Instructions

4. Push the device bay shelf back until it stops, lift the right side
slightly to disengage the two tabs from the divider wall, and
then rotate the right edge downward (clockwise).
5. Lift the left side of the device bay shelf to disengage the three
tabs from the divider wall, and then remove it from the
enclosure.
6. Remove the connector covers.
7. Prepare the server blade for installation.
8. Install the server blade.
CAUTION: To prevent improper cooling and thermal
damage, do not operate the server blade or the enclosure
unless all hard drive and device bays are populated with
either a component or a blank.
9. Install blanks in any empty bays. For more information, see
the enclosure setup and installation guide.

Completing the configuration

To complete the server blade and HP BladeSystem configuration,
see the overview card that ships with the enclosure and also see
the server blade user guide.