Advertisement
2.
Remove the enclosure connector cover.
3.
Install the server blade.
Connecting to the network
To connect the HP BladeSystem to a network, each enclosure must
be configured with network interconnect devices to manage signals
between the server blades and the external network.
Two types of interconnect modules are available for HP BladeSystem
c-Class enclosures: Pass-thru modules and switch modules. For more
information about interconnect module options, see the HP website
(http://www.hp.com/go/bladesystem/interconnects).
Installing interconnect modules
For specific steps to install interconnect modules, see the
documentation that ships with the interconnect module.
Interconnect bay numbering and device
mapping
Each server in the server blade has two embedded Ethernet NIC
ports and an embedded 4x QDR IB/Flex-10 10Gb port. The 4x
QDR IB/Flex-10 10Gb port is automatically configured to match the
switch module installed in bays 5 through 8 in the HP ProLiant
c7000 Enclosure. The HP ProLiant BL2x220c G7 Server Blade is
supported only in the HP ProLiant c7000 Enclosure.
To support network connections for specific signals, install an
interconnect module that supports the preferred mode of operation in
the bay that corresponds with the server node.
Server blade signal
c7000 interconnect
bay
Server A NIC 1
1
Server A NIC 2
3
5 & 6
Server A 4x QDR IB
switch
Server A 10G Ethernet
5
Server B NIC 1
2
Server B NIC 2
4
Server B 4x QDR IB
7 & 8
switch
Server B 10G Ethernet
7
For detailed port mapping information, see the HP BladeSystem
enclosure installation poster or the HP BladeSystem enclosure setup
and installation guide on the HP website
(http://www.hp.com/go/bladesystem/documentation).
Completing the configuration
To complete the server blade and HP BladeSystem configuration, see
the overview card that ships with the enclosure.
For more information
For more detailed setup and configuration information as well as
regulatory, safety, and environmental notices, see the HP ProLiant
BL2x220c G7 Server Blade User Guide on the HP website
(http://www.hp.com/go/bladesystem/documentation).
Interconnect bay
labels
Advertisement
