Connecting To The Network; Installing A Server Blade - HP BL680c - ProLiant - G5 Installation Instructions
Proliant bl680c generation 5 server blade installation instructions
Hide thumbs
Also See for BL680c - ProLiant - G5:
- User manual (111 pages) ,
- Specification (35 pages) ,
- Configuration (23 pages)
Advertisement
Installation is shown in the HP BladeSystem c7000 Enclosure.
Server blade
Interconnect bay
Interconnect bay labels
signal
NIC 1
1
(Embedded)
NIC 2
2
(Embedded)
NIC 3
1
(Embedded)
NIC 4
2
(Embedded)
Mezzanine 1
3 and 4
Mezzanine 2
5 and 6
7 and 8
Mezzanine 3
7 and 8
5 and 6
For detailed port mapping information, see the HP BladeSystem
enclosure quick setup guide or the HP BladeSystem enclosure setup
and installation guide on the HP website
(http://www.hp.com/go/bladesystem/documentation).
Connecting to the network
To connect the HP BladeSystem to a network, each enclosure must
be configured with network interconnect devices to manage
signals between the server blades and the external network.
Two types of interconnect modules are available for HP
BladeSystem c-Class enclosures: Pass-thru modules and switch
modules. For more information about interconnect module options,
see the HP website
(http://www.hp.com/go/bladesystem/interconnects).
Installing a server blade
HP BladeSystem enclosures ship with device bay shelves to support
half-height devices. To install a full-height device, remove the
device bay shelf and the corresponding blanks.
CAUTION: To prevent improper cooling and thermal
damage, do not operate the server blade or the enclosure
unless all hard drive and device bays are populated with
either a component or a blank.
Installation is shown in the HP BladeSystem c7000 Enclosure.
For detailed information on the c7000 or other BladeSystem
enclosures, see the appropriate enclosure setup guide or server
blade user guide.
Enclosure documentation is located at the HP website
(http://h71028.www7.hp.com/enterprise/cache/80316-0-0-0-
121.html).
Server blade documentation is located at the HP website
(http://h18004.www1.hp.com/products/servers/platforms/).
To install a server blade:
1.
Remove the blank.
2.
Remove the three adjacent blanks.
3.
Slide the device bay shelf locking tab to the left to open it.
Advertisement
