Changing The Video Resolution; Startup Applications - Lenovo ThinkCentre A62 Deployment Manual

IPConfig =9.44.72.36
StartNet=Yes
SubnetMask=255.255.255.128
4. Get the \PREBOOT\SWWORK NETSTART.TBI file by using the RRUTIL process described in "Using
RRUTIL.EXE" on page 26.
5. Change
factory -minint
to
factory -winpe
6. Comment out the following lines:
regsvr32 /s netcfgx.dll
netcfg -v -winpe
net start dhcp
net start nla
7. Put the \SWWORK\ NETSTART.TBI and \MININT\SYSTEM32 winbom.ini files back by using the RRUTIL
process described in "Using RRUTIL.EXE" on page 26.
Note: The default environment supports only the DHCP environment.
The following table provides the entry and description for IP configurations:
Table 20. Static IP address entries
Entry
Gateway
IPConfig
StartNet
SubnetMask

Changing the video resolution

You can change the video resolution by changing the default Predesktop Area resolution settings of 800 ×
600 × 16-bit. To change the settings, complete the following procedures:
1. Get the \MININT\SYSTEM32\WINBOM.INI file by using the RRUTIL process described in "Using
RRUTIL.EXE" on page 26.
2. Open the file for editing.
3. Add the following entries:
[ComputerSettings]
DisplayResolution=800x600x16 or 1024x768x16
When the Rescue and Recovery environment starts, you see an additional window during startup that is
titled "Factory preinstallation". The colors are reduced from thousands to 256.
4. Put back the \MININT\SYSTEM32\WINBOM.INI file by using the RRUTIL process described in "Using
RRUTIL.EXE" on page 26.

Startup applications

The Rescue and Recovery Windows PE environment has the ability to support a startup scripts, programs,
or customized programs. These scripts or programs will be processed before the Rescue and Recovery
Windows PE environment reaches the main PE interface page.
Description
Specifies the IP address of an IP router. Configuring a default gateway creates a
default route in the IP routing table. Syntax:
Gateway = xxx.xxx.xxx.xxx
Specifies the IP address that Windows PE uses to connect to a network.
Syntax:IPConfig = xxx.xxx.xxx.xxx
Specifies whether to start networking services. Syntax:StartNet = Yes | No
Specifies a 32-bit value that enables the recipient of IP packets to distinguish
the network ID and host ID portions of the IP address. Syntax:SubnetMask =
xxx.xxx.xxx.xxx
.
Chapter 3 Configurations
41