Password Persistence - Lenovo ThinkCentre A62 Deployment Manual

3. If you want to exclude .mpg and .jpg files from the backups, set the registry entry to include them
at: HKLM\SOFTWARE\Lenovo\Rescue and Recovery\Settings\BackupList. For more information on
including and excluding backups with the registry see Include and exclude backup files with Registry
settings "Include and exclude backup files with registry settings" on page 23.
4. Install the Rescue and Recovery program using MSIEXE:
a. For all MSI files, add the following installation-log generation code:
/L*v %temp%\rrinstall.txt
b. To install the setup files using MSIEXE, type the following command:
: Perform the install of Rescue and Recovery
msiexec /i "C:\TVTRR\Rescue and Recovery.msi"
c. To silently install the setup files using MSIEXE: With reboot at the end, enter the following command:
: Silent install using the MSI with a reboot
: Type the following command on one line
start /WAIT msiexec /i "C:\TVTRR\Rescue and Recovery.msi" /qn
With reboot suppressed, enter the following command:
: Silent install using the MSI without a reboot
: Type the following command on one line
start /WAIT msiexec /i "C:\TVTRR\Rescue and Recovery.msi" /qn REBOOT="R"
5. Enter the following commands:
:Start the Rescue and Recovery Service
net start "TVT Backup Service"
:Create Sysprep Base Backup to Local Hard Drive
: Type the following command on one line
cd "\Program Files\Lenovo\Rescue and Recovery"
rrcmd sysprepbackup location=L name="Sysprep Base Backup"
If you want to use a password, add the syntax password=pass.
6. Run your specific Sysprep implementation when you see the following message:
***************************************************
** Ready to take sysprep backup.
** PLEASE RUN SYSPREP NOW AND SHUT DOWN.
**
** Next time the machine boots, it will boot
** to the Predesktop Area and take a backup.
***************************************************
7. Shut down and reboot the machine when Sysprep is complete.
Note: The operating system will reboot into the Predesktop Area of the Rescue and Recovery program.
The status bar with System Restore in Progress will appear.
8. When complete, the message Sysprep Backup is Complete will appear.
9. Power off the system using the power button.
10. Capture the image for deployment.
Supported Sysprep multiple drive configurations
Windows PE drive enumeration may be different than the Windows main operating system enumeration for
Primary partitions. If you wish to backup to a partition other than C:\ Primary, you must set the Backup
partition type to Extended.
Note: Backups will fail when doing a Sysprep backup if the drive letters of the partitions are changed after
running the Sysprep backup.

Password Persistence

The following table shows considerations for deciding whether to use Password Persistence.
**
**
**
**
**
.
Chapter 3 Configurations
21