Additional Safety Information - HP Pavilion Ultimate d4900 - Desktop PC Support Manual

Canada Department of Communications
(DOC) Notice
Telephone Connection
The Canada Department of Communications label identifies
certified equipment. This certification means that the
equipment meets certain telecommunications network
protective, operational, and safety requirements. The
department does not guarantee the equipment will operate
to the user's satisfaction.
Before installing this equipment, the user should ensure it is
permissible to connect it to the facilities of the local
communications company. The equipment must be installed
using an acceptable method of connection. In some cases,
the company's inside wiring associated with a single line
individual service may be extended by means of a certified
connector assembly (telephone extension cord). The
customer should be aware that compliance with the above
conditions may not prevent degradation of service in some
situations.
Repairs to certified equipment should be made by an
authorized Canadian maintenance facility designated by the
supplier. Any repairs or alterations made by the user to this
equipment, or equipment malfunctions, may give the
telecommunications company cause to request that the user
disconnect the equipment.
Users should ensure, for their own protection, that the
electrical ground connections of the power utility, telephone
lines, and internal metallic water pipe systems, if present,
are connected together. This precaution may be particularly
important in rural areas.
WARNING: Users should not attempt to make
such connections themselves, but should contact
the appropriate electrical inspection authority or
electrician, as appropriate.
WARNING: The Load Number .9 assigned to each
terminal device denotes the percentage of the
total load to be connected to a telephone loop;
this is used by the device to prevent overloading.
The termination on a loop may consist of any
combination of devices, subject only to the
requirement that the sum of the Load Numbers
does not exceed 100.
12
WARNING: When using this device, basic safety
precautions should always be followed to reduce
the risk of fire, electric shock, and injury to
persons, including the following:
•
Do not use this product near water, for
example, near a bathtub, wash bowl, kitchen
sink, or laundry tub, in a wet basement, or
near a swimming pool.
•
Avoid using this product during an electrical
storm. There may be a remote risk of electric
shock from lightning.
•
Do not use this product to report a gas leak in
the vicinity of the leak.
•
Always disconnect the modem cable before
opening the equipment enclosure or touching
an uninsulated modem cable, jack, or internal
components.
•
If this product was not provided with a
telephone line cord, use only No. 26 AWG or
larger telecommunication line cord in order to
reduce the risk of fire.
•
Do not plug a modem or telephone cable into
the Network Interface Card (NIC) receptacle.
SAVE THESE INSTRUCTIONS
DOC Statement (Canada Only)
This Class B digital apparatus meets all requirements of the
Canadian Interference-Causing Equipment Regulations.

Additional Safety Information

This product has not been evaluated for connection to an
"IT" power system (an AC distribution system with no direct
connection to earth, according to IEC 60950).
This equipment meets the applicable Industry Canada
Terminal Equipment Technical Specifications. This is
confirmed by the registration number. The abbreviation, IC,
before the registration number signifies that registration was
performed based on a Declaration of Conformity indicating
that Industry Canada technical specifications were met. It
does not imply that Industry Canada approved the
equipment.