Additional Safety Information - HP Media Center m1000 - Desktop PC Support Manual

WARNING: The Load Number .9 assigned to
each terminal device denotes the percentage of
the total load to be connected to a telephone
loop; this is used by the device to prevent
overloading. The termination on a loop may
consist of any combination of devices, subject
only to the requirement that the sum of the Load
Numbers does not exceed 100.
WARNING: When using this device, basic safety
precautions should always be followed to reduce
the risk of fire, electric shock, and injury to
persons, including the following:
•
Do not use this product near water; for
example, near a bathtub, wash bowl, kitchen
sink, or laundry tub, in a wet basement, or
near a swimming pool.
•
Avoid using this product during an electrical
storm. There may be a remote risk of electric
shock from lightning.
•
Do not use this product to report a gas leak in
the vicinity of the leak.
•
Always disconnect the modem cable before
opening the equipment enclosure or touching
an uninsulated modem cable, jack, or internal
components.
•
If this product was not provided with a
telephone line cord, use only No. 26 AWG or
larger telecommunication line cord in order to
reduce the risk of fire.
•
Do not plug a modem or telephone cable into
the Network Interface Card (NIC) receptacle.
SAVE THESE INSTRUCTIONS
DOC Statement (Canada Only)
This Class B digital apparatus meets all requirements of the
Canadian Interference-Causing Equipment Regulations.

Additional Safety Information

This product has not been evaluated for connection to an
"IT" power system (an AC distribution system with no direct
connection to earth, according to IEC 60950).
This equipment meets the applicable Industry Canada
Terminal Equipment Technical Specifications. This is
confirmed by the registration number. The abbreviation, IC,
before the registration number signifies that registration was
performed based on a Declaration of Conformity indicating
that Industry Canada technical specifications were met. It
does not imply that Industry Canada approved the
equipment.
22
AC Power Safety Warning
WARNING: Install the computer near an AC
outlet. The AC power cord is your PC's main AC
disconnecting device and must be easily
accessible at all times. For your safety, the
power cord provided with your PC has a
grounded plug. Always use the power cord with
a properly grounded wall outlet, to avoid the
risk of electrical shock.
WARNING: Your PC is provided with a voltage
select switch for use in a 115V
power system. The voltage select switch has
been pre-set to the correct voltage setting for use
in the particular country/region where it was
initially sold. Changing the voltage select switch
to the incorrect position can damage your PC
and void any implied warranty.
WARNING: To reduce the possibility of an electric
shock from the telephone network, plug your
computer into the AC outlet before connecting it
to the telephone line. Also, disconnect the
telephone line before unplugging your computer
from the AC power outlet.
WARNING: Always disconnect the modem cord
from the telephone system before installing or
removing your computer cover.
WARNING: Do not operate the computer with the
cover removed.
WARNING: For your safety, always unplug the
PC from its power source and from any
telecommunications systems (such as telephone
lines), networks, or modems before performing
any service procedures. Failure to do so may
result in personal injury or equipment damage.
Hazardous voltage levels are inside the power
supply and modem of this product.
Lithium Battery Caution
WARNING: The PC uses a lithium battery, type
CR2032. There is danger of an explosion if the
battery is incorrectly replaced. Replace only with
the same, or equivalent, type recommended by
the manufacturer. Dispose of used batteries
according to the manufacturer's instructions.
or 230V