Sony Handycam NEX-VG30E Instruction & Operation Manual page 92

A photo cannot be captured from a movie
(NEX-VG30/VG30H).
The memory card where you want to save

photos is full.
Playback on the TV
Neither image nor sound is played on the
connected TV.
When you are using the component A/V

cable, set [Component] according to the
requirements of the connected device (p. 82).
When you are using the component video

plug, make sure the red and white plugs of the
A/V connecting cable are connected (p. 37).
Images are not output from the HDMI OUT

jack, if copyright protection signals are
recorded in the images.
When you are using the S VIDEO plug,

make sure the red and white plugs of the A/V
connecting cable are connected (p. 38).
When [24p Mode] is activated, recorded

images may not be played back even though
the camcorder is connected to a PAL-based
TV (NEX-VG30E/VG30EH).
The top, bottom, right, and left edges
of images are trimmed slightly on a
connected TV.
The LCD screen of your camcorder can

display recording images across the entire
screen (full pixel display). However, this may
cause slight trimming of the top, bottom, right,
and left edges of images when played back on
a TV which is not compatible with full pixel
display.
It is recommended you record images using

the outer frame of [Guide Frame] (p. 76) as
a guide.
The image appears distorted on the 4:3
TV.
This happens when viewing an image

recorded in the 16:9 (wide) mode on a 4:3 TV.
Set [TV Type] correctly (p. 82) and play back
the image.
Black bands appear at the top and bottom
of the screen of the 4:3 TV.
This happens when viewing an image recorded

in the 16:9 (wide) mode on a 4:3 TV. This is
not a malfunction.
Copying/Connecting to other
devices
Images are not copied correctly.
You cannot copy images using the HDMI

cable (sold separately).
The A/V connecting cable is not connected

properly. Make sure to connect the cable to the
input jack of another device (p. 63).
Connecting to a computer
"PlayMemories Home" cannot be installed.
Check the computer environment or

installation procedure required to install
"PlayMemories Home. "
"PlayMemories Home" does not work
correctly.
Quit "PlayMemories Home" and restart your

computer.
The camcorder is not recognized by the
computer.
Disconnect devices from the USB jack of the

computer other than the keyboard, mouse,
and your camcorder.
Disconnect the USB cable (supplied) from the

computer and your camcorder, and restart
the computer, then connect the computer and
your camcorder again in the correct order.
GB