Asus P2B-VM User Manual page 21

III. INSTALLATION
2. Attach the Heatsink
NOTE: Follow carefully the heatsink attachment instructions included with your
heatsink or processor. The following steps are provided only as a general guide
and may not reflect those for your heatsink.
SECC with Pentium
Place the SECC face down on a flat surface and lay the heat sink flush on the
back (metal side) of the SECC. Check the orientation of the heatsink against the
illustration below. The thicker fin must be orientated toward the bottom. The top
clamp is wider than the bottom clamp so only this orientation will fit. With a
screw driver, push the clamps one at a time into the SECC. Be sure that the
heatsink is firmly pressed against the SECC.
Lock
SECC2 with Pentium
Insert the heatsink clip through the holes at the SECC2/SEPP's back, making sure that
the bottom of the clip plate sits against the processors's back. Remove the tab from the
thermal grease, which is located on the bottom of the heatsink) and place the heatsink
over the processor. A slight rocking motion may be necessary to place the heatsink on the
SECC2/SEPP, with one pair of the heatsink clip legs going first through the correspond-
ing heatsink holes, and then the other pair. (NOTE: The heatsink and SECC2/SEPP
holes are slightly offset to ensure good locking grip between the two.)
SECC2/SEPP
WARNING!
Make sure the heatsink is mounted tightly against the SECC, SECC2
or SEPP; otherwise, the CPU will overheat. You may install an auxiliary fan to
provide adequate circulation across the processor's passive heatsink.
®
II
Push each end of the clamps until they lock
®
II/SEPP with Celeron™
Heatsink Clip Legs
ASUS P2B-VM User's Manual
Lock
21