See "Removing The Battery Pack" On - Acer Aspire 4741 Service Manual

Removing the Touchpad Board
1. See "Removing the Battery Pack" on page 30.
2. See "Removing the SD Dummy Card" on page 31.
3. See "Removing the Back Cover" on page 32.
4. See "Removing the DIMM Modules" on page 33.
5. See "Removing the Hard Disk Drive Module" on page 34.
6. See "Removing the Wireless WAN Module" on page 36.
7. See "Removing the WLAN Module" on page 37.
8. See "Removing the Optical Drive Module" on page 39.
9. See "Removing the Keyboard" on page 43.
10. See "Separating the Upper Case from the Lower Case" on page 44.
11. Release the latch and disconnect the the touchpad cable from its connector the touchpad board.
12. Pry to loosen the touchpad board and detach it from the upper case.
WARNING: The touchpad board is glued to the upper case, only remove the touchpad board if it is defective.
Note: Circuit board >10 cm² has been highlighted with the yellow rectangle as above image shows.
Please detach the Circuit boards and follow local regulations for disposal.
Chapter 3 51