Backup Battery Installation - VTech Touch Tablet Advanced User Manual

Important: When replacing the 4 "AA" size batteries, make sure the backup batteries are
in the unit. Otherwise you will lose any information stored on the unit.

BACKUP BATTERY INSTALLATION

Your Touch Tablet™ comes with a backup battery already installed. To avoid damage to
the unit from leaky batteries, replace the backup battery at least once a year.
TO REPLACE THE BACKUP BATTERY
1. Make sure the unit is OFF.
2. Using a small cross-head screwdriver, loosen the battery cover.
3. Insert 1 CR2032 size battery as illustrated.
4. Close the battery cover and tighten the screws to secure it.
Important: While replacing the backup battery, the 4 "AA" size batteries
must be kept in the unit. Otherwise, you will lose any saved
information.
STANDARD FOR BATTERY TOYS
• Do not try to recharge non-rechargeable batteries;
• Rechargeable batteries are to be removed from the toy before being charged;
• Rechargeable batteries are only to be charged under adult supervision;
• Do not mix different types of batteries; Do not mix new and used batteries;
• Only use batteries of the recommended or equivalent type;
• Always insert batteries properly matching the plus (+) and minus (-) signs;
• Batteries that have run out of energy must be removed from the toy;
• Do not short-circuit the supply terminals;
• Do not use more batteries than recommended;
• Remove batteries from the toy if it will not be used for an extended period of time.
AC-DC ADAPTOR
Use a VTech ® adaptor or any other standard adaptor that complies with EN61558 DC 9V
300mA
CONNECTING THE ADAPTOR
1. Make sure the unit is OFF.
2. Locate the adaptor jack on the side of the unit.
3. Insert the adaptor plug into the unit's adaptor jack.
4. Plug the adaptor into a wall outlet.
5. Turn the unit ON.
NOTE: When the toy is not going to be in use for an extended period of time, unplug the
adaptor.
center-positive adaptor.
3