Assembling The Blades; Installing The Light Fixture - Hunter 28425 Installation & Operation Manual

8 8 8 8 8
Tab Indicator
Canopy
Figure 19 - Removing the canopy trim ring

assembling the blades

Hunter fans use several styles of fan blade irons (brackets that hold
the blade to the fan).
1. Your fan may include blade grommets. If your fan has grom-
mets, insert them by hand into the holes on the blades as shown
in Figure 20.
Figure 20 - Inserting the grommets into the fan blades
2. Attach each blade to blade iron using three blade assembly
screws as shown in Figure 21. Some fans feature a decorative
medallion as well as a blade iron. Insert the assembly screws
into the blade iron, through the blade and into the medallion,
with the blade sandwiched between the blade iron and me-
dallion as shown in Figure 22.
Figure 21 - Attaching the blade to the blade iron
41860-01 02/24/2005
Canopy Trim Ring
Grommet
Fan Blade
Blade Iron
Medallion
Figure 22 - Attaching the blade to the
blade iron and medallion
If you used grommets, the blades may appear slightly loose
after screws are tightened. This is normal.
3. Remove the blade mounting screws and rubber shipping
bumpers from the motor.
4. For each blade, insert one blade mounting screw through the
blade iron as shown in Figure 23, and attach lightly to the fan.
Insert the second blade mounting screw, then securely tighten
both mounting screws.
Figure 23 - Attaching the blade iron to the fan

installing the light fixture

1. Partially install two of the #6-32 x 3/8" screws into the mount-
ing plate as shown in Figure 24.
2. Insert the plug connector from the fan through the hole in the
switch housing as shown in Figure 24.
Mounting Plate
Figure 24 - Installing the switch housing
3. Line up the key slots in the switch housing with the two par-
tially installed screws. Twist in place. Line up the third hole
and insert the screw.
Switch Housing
Plug Connector
© 2005 Hunter Fan Company