Troubleshooting; Please Do Not Return This Product To The Store - Bissell Rewind PowerHelix User Manual

T
roubleshooting
Vacuum cleaner won't turn on
possible causes
1. Power cord not plugged in
2. Blown fuse/tripped breaker
3. Damaged cord
Vacuum cleaner won't pick up
possible causes
1. Incorrect height adjustment
2. Hose not attached to suction opening
3. Crack or hole in hose
4. Broken or worn drive belt
5. Rotating floor brush bristles worn
6. Rotating floor brush jammed
7. Clog in vacuum
8. Dirt container full
9. Dirt container or upper tank not installed properly
10. Filters are dirty
Tools won't pick up
possible causes
1. Crack or hole in hose
2. Clog in vacuum
3. Dirt container full
4. Dirt container or upper tank not installed properly
5. Filters are dirty
Visible dirt escaping from cleaner
possible causes
1. Dirt container full
2. Filters missing or installed incorrectly
cord will not retract
possible causes
1. Knotted or twisted
other maintenance or service not included in the manual should be
performed by an authorized service representative.

please do not return this product to the store.

for any questions or concerns, bissell is happy to be of service.
12
w w w . b i s s e l l . c o m w w w . b i s s e l l . c o m
thank you for selecting a bissell product.
contact us directly at 1-800-237-7691.
Remedies
1. Check electrical plug
2. Check/replace fuse or reset breaker
3. Refer to a BISSELL authorized service center for repair or
replacement
Remedies
1. Adjust powerfoot to correct height setting
2. Grasp quick reach handle and firmly push hose wand onto
the suction opening
3. Check hose and replace if needed
4. Replace drive belt, see page 10
5. Replace brush
6. Remove brush and clean debris from brush ends
7. Follow instructions on page 11 for clearing clogs
8. Empty dirt container
9. Position correctly and lock in place
10. Check and clean pre-motor and post-motor
filters, see pages 8 & 9
Remedies
1. Check hose and replace if needed
2. Follow instructions on page 11 for clearing clogs
3. Empty dirt container
4. Position correctly and lock in place
5. Check and clean pre-motor and
post-motor filters
Remedies
1. Empty dirt container
2. Check pre-motor and post-motor filters for correct installation
Remedies
1. Follow instructions on page 6
8 0 0 . 2 3 7 . 7 6 9 1 8 0 0 . 2 3 7 . 7 6 9 1