3.6.3
Onboard Devices Configuration
Onboard Devices Configuration
HD Audio Azalia Device
Front Panel Type
SPDIF OUT Type
POST State LEDs
Serial Port1 Address
Serial Port1 Mode
Onboard LAN
Onboard LAN Boot ROM
Onboard 1394 Controller
On Board ATA Controller
On Board ATA Controller ROM
Onboard USB 3.0 Controller
HD Audio Azalia Device [Enabled]
Allows you to enable or disable the HD Audio controller.
Configuration options: [Auto] [Disabled] [Enabled]
The following three items appear only when you set the HD Audio Azalia Device item to
[Enabled] or [Auto].
Front Panel Type [HD]
Allows you to set the front panel audio connector (AAFP) mode to legacy AC'97 or
high-definition audio depending on the audio standard that the front panel audio
module supports.
[AC 97]
[HD]
SPDIF OUT Type [SPDIF]
If your graphics card has HDMI output and needs to use SPDIF signal from the
SPDIF_Out header, you need to set to HDMI for HDMI audio output.
[SPDIF]
[HDMI]
POST State LEDs [Enabled]
[Enabled]
[Disabled]
Serial Port1 Address [3F8/IRQ4]
Allows you to select the Serial Port1 base address.
Configuration options: [3F8/IRQ4] [2F8/IRQ3] [3E8/IRQ4] [2E8/IRQ3]
Serial Port1 Mode [Normal]
Allows you to select the Serial Port1 mode.
Configuration options: [Normal] [IrDA] [ASK IR]
3-24
BIOS SETUP UTILITY
Advanced
[Enabled]
[HD]
[SPDIF]
[Enabled]
[3F8/IRQ4]
[Normal]
[Enabled]
[Disabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
Sets the front panel audio connector (AAFP) mode to legacy AC'97
Sets the front panel audio connector (AAFP) mode to high definition audio.
Sets to [SPDIF Output] for SPDIF audio output.
Sets to [HDMI Output] for HDMI audio output.
Enables the onboard DRAM_LED.
Disables this function.
Allows BIOS to select
Serial Port1 Base
Addresses.
Chapter 3: BIOS setup