Internal Connectors - Asus M4A89TD PRO/USB3 User Manual

2.7.3

Internal connectors

1. IDE connector (40-1 pin PRI_EIDE)
The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. There are
three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray.
Connect the blue connector to the motherboard's IDE connector, then select one of the
following modes to configure your device.
Single device
Two devices
• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA
cable connector. This prevents incorrect insertion when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
If any device jumper is set as "Cable-Select", ensure that all other device jumpers have the
same setting.
ASUS M4A89TD PRO Series
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
Mode of device(s) Cable connector
-
Master
Slave
Master
Black or gray
Slave
Black
Black
Gray
2-27