Table of Contents
Advertisement
Effective range
• Point the remote control at remote sensor on LCD monitor.
About the remote control
• Do not drop, shake or bump.
• Do not wet, do not place on wet materials.
• Do not dismantle.
• Do not place in locations exposed to high temperature or high humidity levels.
Remote control hand unit emits Infra-Red
light, modulated by the internal codes. Do not
try to look into the light even it cannot be seen.
The receiver is located at the power indicator
area, with operation angle and distance
shown in picture.
Note:
1.
Do not disassemble remote control.
2.
Do not drop, give shock to it.
3.
Avoid any water getting into remote control.
4.
Avoid high temperature outdoor use.
Turn On the power
Finish connecting all displays before turning on the power. The hard switch is located at the
rear of the display, and is a full on-off switch. The 'Power' push button on the remote control is
a soft-on-off switch.
control Power button to place display in STAND-BY or ON mode.
Key button on the remote control (* indicates that the side key switch on the display also works)
* POWER:
* MENU:
*
up:
*
down:
* < left:
* > right:
* ENTER:
* EXIT:
AUTO:
SOURCE:
PIP:
SWITCH:
These 8 functions (*) may also be controlled by buttons located on
the side of the product as indicated in picture. The additional
3 functions such as Auto, PIP and Switch are controlled only by
the hand remote control. Refer to the next page enlarged keys too.
Be sure to turn on the hard switch first to operate. Now depress remote
selection of ON or STAND-BY, lamp and driver power supply are reduced.
to enter 1
MENU page
st
Main Menu Item selection
Main Menu Item selection
Sub Menu selection or value change
Sub Menu selection or value change
Selected value / Menu, ENTER
Exit from Selected Menu
Automatic configuration/Centering
Input selection
Picture in Picture selection
Picture-in-picture image switch
WIRELESS REMOTE CONTROL OPERATION
19
+- 10 degrees
left to right
Advertisement
Table of Contents
