Using The Metronome - Yamaha NU1 Owner's Manual

Basic Operations and More

Using the Metronome

The metronome feature is convenient for practicing with an accurate tempo.
1
Press [METRONOME] to start the metronome.
While the metronome sounds, a dot at the right side of the LED display and the
lamp of the metronome button flash on and off to the tempo.
120.
2
Press [METRONOME] again to stop the metronome.
Adjusting the Tempo
During the operation described below, you can check the tempo value shown on the
display.
 To increase or decrease the value by 1:
While holding down [METRONOME], press [+] (or C#5 key) or [-] (or B4 key). Dur-
ing playback, simply press [+] or [-].
 To increase or decrease the value by 10:
While holding down [METRONOME], press the D5 or A#4 key.
 To reset the value to the default (120):
While holding down [METRONOME], press the C5 key or press [+] and [-] simulta-
neously. During playback, press both [+] and [-] simultaneously.
Selecting the Beat
While holding down [METRONOME], press one of the C3–F3
keys. The selected value is shown on the display while both
controls are held.
Display Key
0
C3 0 (no downbeat)
2
C#3
3
D3
Only the first beat is accented with a bell sound when set to a value other than 0.
Adjusting the Metronome volume
While holding down [METRONOME], press one of the C1–G2 keys to set the vol-
ume. The specified value is shown on the display while both controls are held.
14 NU1
Owner's Manual
The beat lamp flashes
at the current tempo
A#4
B4 C5 D5
C3 F3
Beat Display Key
4
D#3
5
2 E3
6
3 F3
min.
C1 (1) D2 (15)
The volume level increases as you press higher keys
C#5
Beat
4
5
6
max.
G2 (20)
Setting range: 5 to 500 beats per minute
Default setting: 120
NOTE
The metronome tempo is restored to the
default setting when the power is turned off.
Default setting: 0 (No downbeat)
0
NOTE
The Beat of the metronome is restored to
the default setting when the power is turned
off.
Beat
Setting range: 1–20
Default setting: 15
NOTE
The metronome volume setting is retained
even when the power is turned off.