3.
IDE connector (40-1 pin PRI_IDE)
The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. There are three
connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect the blue
connector to the motherboard's IDE connector, then select one of the following modes to configure
your device.
Single device
Two devices
•
•
If any device jumper is set as "Cable-Select," make sure all other device jumpers have the
same setting.
2-28
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA
cable connector. This prevents incorrect insertion when you connect the IDE cable.
Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
Mode of device(s)
Cable connector
-
Black
Black
Master
Slave
Gray
Master
Black or gray
Slave
Chapter 2: Hardware information