Main Menu; Primary Ide Master/Slave; Sata 1-5; Esata - Asus M4A78T-E - Motherboard - ATX User Manual

3.4

Main menu

When you enter the BIOS Setup program, the Main menu screen appears, giving you an
overview of the basic system information. You can set the system time and date, BIOS
language, and the type of floppy drive installed.
Refer to 3.3.1 BIOS menu screen for information on the menu screen items and how to
navigate through them.
Main Ai Tweaker Advanced Power Boot Tools Exit
System Time
System Date
Legacy Diskette A
Language
Primary IDE Master
Primary IDE Slave
SATA1
SATA2
SATA3
SATA4
SATA5
ESATA
Storage Configuration
System Information System Information
v02.61 (C)Copyright 1985-2008, American Megatrends, Inc.
3.4.1

Primary IDE Master/Slave; SATA 1-5; ESATA

Primary IDE Master/Slave; SATA 1-5; ESATA
While entering Setup, the BIOS automatically detects the presence of IDE/SATA devices.
There is a separate submenu for each IDE/SATA device. Select a device item then press
<Enter> to display the SATA device information.
Main
Primary IDE Master
Device : Hard Disk
Vendor : WDC WD800JD-00LSA0
Size : 80.0GB
LBA Mode : Supported
Block Mode : 16 Sectors
PIO Mode : 4
Async DMA : MultiWord DMA-2
Ultra DMA : Ultra DMA-5
SMART Monitoring: Supported
Type
LBA/Large Mode
Block(Multi-sector Transfer)M [ Auto]
PIO Mode
DMA Mode
SMART Monitoring
32Bit Data Transfer
v02.61 (C)Copyright 1985-2008, American Megatrends, Inc.
The BIOS automatically detects the values opposite the dimmed items (Device, Vendor, Size,
LBA Mode, Block Mode, PIO Mode, Async DMA, Ultra DMA, and SMART monitoring). These
values are not user-configurable. These items show N/A if no IDE device is installed in the
system.
ASUS M4A78T-E
BIOS SETUP UTILITY
[10:55:25]
[Tue 12/09/2008] 8] ]
[1.44M, 3.5 in.]
[English]
[Not Detected]
[Not Detected]
[HDT722516DLA380]
[Not Detected] Not Detected] ]
[Not Detected]
[Not Detected]
[Not Detected]
[Not Detected]
SATA 1-5; ESATA
BIOS SETUP UTILITY
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Enabled]
Use [ENTER], [TAB]
or [SHIFT-TAB] to
select a field.
Use [+] or [-] to
configure the System
Time.
Select Screen
Select Item
+-
Change Field
Tab Select Field
F1 General Help
F10 Save and Exit
ESC Exit
Select the type of
device connected to
the system.
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
3-9