Table of Contents
Advertisement
4.4.2
Installing Serial ATA hard disks
The motherboard supports Serial ATA hard disk drives. For optimal performance, install
identical drives of the same model and capacity when creating a disk array.
To install the SATA hard disks for a RAID configuration:
1.
Install the SATA hard disks into the drive bays.
2.
Connect the SATA signal cables.
3.
Connect a SATA power cable to the power connector on each drive.
4.4.3
AMD
This motherboard supports RAID 0, RAID 1, RAID 5, and RAID 10 configurations for Serial
ATA hard disks drives through the AMD SB750 chip.
Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID set. To do this:
1.
Install the internal Serial ATA hard disk drives to the SATA connectors labeled
SATA_1/2/3/4/5.
2.
Boot up your computer, and press <Del> during POST to enter the BIOS setup.
3.
In the Main Menu, go to Storage Configuration, and set the OnChip SATA Type item
to [RAID].
3.
Press <F10> to save the changes and exit.
The RAID BIOS setup screens shown in this section are for reference only, and may not
exactly match the items on your screen.
4-14
RAID configurations
®
Chapter 4: Software support
Hide quick links:
Advertisement
Table of Contents
