Drain Hose Connection - Haier HW50-1010 Installation And User Instructions Manual

Installation
Drain hose connection - options
Three connection options are available:
General notes: The end of the drain hose must
not be under water, it must be secur ely fixed
and leak-free. If the drain hose is placed on the
ground or the height of the pipe is less than
80cm, the washing machine will continuously
drain while being filled (self-syphoning).
It is recommended that the drain hose is not
extended unless absolutely necessary, the
extension must be of the same diameter and no
longer than 250cm.
Option 1: Into a drainage standpipe
The standpipe should have an internal diameter
of approximately 38mm, this will allow for an air
gap between the pipe and hose.
Option 2: Into a sink outlet spigot
If the outlet spigot has not been used before,
first remove any blanking plug that may be
fitted.
Push fit the drain hose onto the spigot and fix in
place using a securing clip.
Note: Ensure there is a raised loop in the drain
hose to prevent waste water from the sink
entering the washing machine.
Option 3: Directly into a sink
Use the hose clip to hook the drain hose directly
over the side of a sink (ensuring the hose is at
the correct height).
Option 1
Drainage
standpipe
Option 2
Sink outlet
spigot
Option 3
Sink
Raised
loop
6