Epson SureColor T3000 User Manual page 27

Keep cut sheets in their original package after opening, and keep them in a flat place.
O
Remove roll paper that is not in use from the printer. Rewind it correctly and then store
O
it in the original packaging that came with the roll paper. If you leave the roll paper in the
printer for a long time, its quality may decline.
Notes on handling printed paper
To maintain long lasting, high quality print results, note the following points.
Do not rub or scratch the printed surface. If they are rubbed or scratched, the ink may
O
peel off.
Do not touch the printed surface; failure to observe this precaution may cause ink to rub
O
off.
Make sure the printouts are completely dry before folding of stacking; otherwise, the
O
color may change where they touch (leaves a mark). These marks will disappear if they
are separated immediately and dried; however, they will remain if not separated.
If you put the printouts in an album before they are completely dry, they may be blurred.
O
Do not use a dryer to dry the printouts.
O
Avoid direct sunlight.
O
Prevent color distortion while displaying or storing the printouts by following the
O
instructions in the paper's documentation.
Note:
Typically, printouts and photos fade over time (color distortion) due to the effects of light and
various constituents in the air. This also applies to Epson special media. However, with the
correct storage method, the degree of color distortion can be minimized.
See the documentation supplied with Epson special media for detailed information on
O
handling the paper after printing.
The colors of photos, posters, and other printed materials appear different under different
O
lighting conditions (light sources
different under different light sources.
* Light sources include sunlight, fluorescent light, incandescent light, and other types.
*
). The colors of printouts from this printer may also appear
Introduction 27