Section Ii - Digitally-Tuned Pll Am/Fm Radio - Oregon Scientific RRM968P Instruction Manual

using [VOL +] or [VOL -]. Press [ALARM] to confirm the
entry and exit the setting mode. Press [RADIO] to turn off the
radio.
When the pre-set time arrives, beep sound / radio will be turned on.
Press any key to stop the beep sound. The EL backlight and projection
will also activate for 5 seconds.
To enable/disable the alarm, press [ALARM ON/OFF ] when the
main unit is in Alarm display mode
When [SNOOZE/LIGHT] is pressed to stop the alarm sound (only
when Beep Alarm mode is selected), the unit will re-alarm again
after 8 minutes. To disable the snooze function, press [ALARM]
or [ALARM ON/OFF ] or press and hold [SNOOZE/LIGHT] for
3 seconds when alarm goes off.
Please note that when Radio is on while Beep Alarm goes off at the
same time, the Radio will be temporarily stopped until the Beep
Alarm has been turned off.
NOTE ON RADIO ALARM
When the Radio Alarm is turned on, the Radio will be turned on for
2 hours. You can intervene by setting the time period for the Sleep
function by pressing [SLEEP] or simply turn off the radio at any
time.
HOURLY CHIME FUNCTION
When the hourly chime function is on, the indication "
be displayed and a beep sound will be given out at the beginning of
8
RRM968PM_EN_R0
each hour. You can activate or deactivate this function by setting
this in the clock and calendar setting mode (please refer to Section
"SETTING THE CLOCK AND CALENDAR MANUALLY").
Section II - Digitally-tuned PLL AM/FM
Radio
HOW TO USE THE RADIO
Before you start - All radio functions can only be operated when
Radio is powered on.
To turn on the radio press [RADIO]. The radio will be turned on at
the last preset radio station and volume.
To change the radio frequency, press [AM/FM] to select the radio
band. Then use [+TUNING -] to locate the desired radio frequency.
Press once and the value will advance by 1 step. Press and hold for
2 seconds to enter the Radio Channel auto-search function.
To change the volume, use [VOL +] or [VOL -] to increase or
decrease the volume.There are a total of 16 (0-15) - steps.
To toggle among the programmed stations, press [STATION].
To turn off the radio, press [ RADIO ].
AUTO-SEARCH FUNCTION
The unit is equipped with an Auto-Search function and can
automatically search for the next clear channel. To activate this
" will
function, press and hold [+TUNING -] for 2 seconds and
automatically the value of the frequency will keep increasing or
8
7/7/04, 11:01 AM