Table of Contents
Advertisement
Input Source Selection (RGB (PC digital), RGB (AV HDCP))
Direct Operation
Choose Computer 1(Digital) by pressing the INPUT button
on the top control or press the COMPUTER button on the
remote control.
Before using these buttons, correct input source should be
selected through Menu operation as described below.
Menu Operation
1
Press the MENU button to display the On-Screen
Menu. Use the Point
frame pointer to the Input Menu icon.
2
Use the Point
ed
buttons to move the red arrow
pointer to Computer 1 (Digital), and then press the
SELECT button.
3
After the Source Select Menu appeared for Computer
1 (Digital), move the pointer to RGB (PC digital) or RGB
(AV HDCP), and then press the SELECT button.
✔
Notes:
•Computer 2 (COMPUTER IN 2/COMPONENT IN) can accept only
RGB signal.
•HDCP (High-bandwidth Digital Content Protection) is a system for
protecting digital entertainment content delivered by DVI (Digital
Visual Interface) from being copied. The specification of HDCP is
decided and controlled by Digital Content Protection, LLC. Should
the specification be changed, this projector may not display the
digital content protected by HDCP.
•Wired, Wireless, Memory viewer are for the Network function.
See owner's manual "Network Set-up and Operation" and owner's
manual of Memory viewer (optionally available).
•When the Input Search function is set to "On1" or "On2", the
input signal will be searched automatically (p.51).
7 8
buttons to move the red
Top Control
INPUT button
Computer 1 (Analog)
Computer 1 (Digital)
Remote Control
COMPUTER button
Computer 1 (Analog)
Computer 1 (Digital)
Input Menu icon
Input Menu
Computer
1
Computer Input
Computer 2
Video
Wired
Computer 2
Move the pointer
(red arrow) to
Computer 1 (Digital)
and press the
SELECT button.
Move the pointer to
the source that you
want to select and
press the SELECT
button.
31
Advertisement
Table of Contents
