VTech vt20-2480 User Manual page 7

Your VTech GIGAPHONE system can operate up to 8 Handsets.
The VTECH accessory Handset consists of the following:
12
Plug the AC power adapter into
an electrical outlet.
Remove the Handset battery
cover by pressing on the indent
and sliding downward.
Place the new battery pack in
the Handset, with the metal
contacts aligned with the charge
contacts in the battery
compartment.
Replace the battery cover by
sliding it upward.
Place the Handset in the Charge
Cradle, and allow it to charge
for 12 hours. After the initial
charge, a maintenance charge of
8 hours should be sufficient.
Enter Base ID Code
1. After charging the Handset, remove it
from its Charge Cradle; the screen will
display:
alternating with this screen:
2. If, after charging the Handset, you see:
3. Press NEW. You will now see the
ENTER BASE ID screen as described in
step 1.
4. Find the BASE ID Code by doing the
following: (the Base must be in idle
(OFF) mode)
A. At the Base, press MENU
B. Scroll down to DISPLAY BASE-ID
C. Press OK. The Base screen will
display the 15-digit ID Code.
Afterwards, it will return the idle screen.
5. Enter the 15-digit Base ID Code into the
Handset; then press OK.
6. Wait approximately 15 to 60 seconds.
You will hear confirmation beeps from
the Base and Handset. The newly
registered Handset will now assign
itself the lowest handset number not
previously assigned to a different system
Handset (1 through 8).
7. If the Handset displays REJECTED BY BASE or continues to display
SEARCHING FOR BASE for well beyond 60 seconds, try the registration
process again by repeating the above steps.
Congratulations! You can now enjoy the benefits of your 2-Line VTECH Multi-
Handset system.
13