VTech vt20-2480 User Manual page 12

Handset Deregistration
You can deregister all Handsets at one time. This causes the Base Unit to 'forget'
that it has any Handsets at all. You may never have to perform this procedure.
One possible reason for deregistration is if you have the maximum number
of Handsets (8) registered to your Base, and one Handset should require
replacement, the Base will not register the 'new' Handset, because its eight
memory slots are occupied. The deregistration procedure will clear the Base
Unit's memory, and you will be able to register each Handset again. Individual
Handsets cannot be deregistered.
CAUTION: Once you deregister, your Handsets will not be capable of making
or receiving calls. you will need to re-register each Handset, one at at time!!
To Deregister all Handsets:
•
At the Base Unit, in the idle (OFF) mode, press MENU.
•
Scroll down to SETUP BASE, then press OK.
•
Scroll down to DEREGISTER ALL, then press SET.
All system Handsets have been deregistered. To register your Handsets again,
see Registration and Operation, located in the Getting Started section of the
User's Manual, for details.
Register
Use this option to register a Handset to the GIGAPHONE Base. You can register
a total of eight Handsets to the GIGAPHONE Base. This process is activated
automatically whenever a new handset is powered up in range of the
GIGAPHONE Base.
You will be prompted to enter the 15-digit Base ID code. See Registration and
Operation, located in the Getting Started section of the manual, for details.
Note : Base ID codes are 15 digits long and can include the following
characters: 0, 1, 2, 3, 4, 5, 6, 7, 8, 9,
*
Memory
The Base and each Handset can store up to 50 names/numbers in memory.
Each memory location can hold up to 32 digits and up to 16 characters for
the name.
When prompted to ENTER NAME, use the digit keys to 'spell' the name. Each
press of a particular key causes characters to be displayed in the following order:
Number Key Characters (in order)
1
2
3
4
5
6 M N O 6 m n o 6
7 P Q R S 7 p q r s 7
8
9 W X Y Z 9 w x y z 9
0
*
#
22
, or # .
& ' , . 1
A B C 2 a b c 2
D E F 3 d e f 3
G H I 4 g h i 4
J K L 5 j k l 5
T U V 8 t u v 8
0
*
#
To Store a Number/Name
• Starting from the idle screen,
enter the number you want to
store in memory. If you make
a mistake, press CLEAR to
backspace.
• Be sure to include long distance
codes and pauses, (using the
Pause softkey) if necessary.
Press the MEM softkey.
• You will then be prompted to
ENTER NAME. Use the digit
keys to 'spell' the name. If you
make a mistake, press the CLR
softkey. To enter a space press
aa . When finished, press
SAVE.
• If there is space available in
memory, the number/name
will be saved and the Handset
will return to idle mode.
• If the memory is full the Handset
will display PHONEBOOK IS
FULL and exit to the idle screen
without saving the entry.
• Follow the above procedure for
storing Number/Names at the
Base. The Handset and Base
have separate memories.
23