Setting The Options; Setting The Delays - X10 SC1200 Owner's Manual

Installation
Setting Options
Press either of the Menu up/down buttons (under the lid to the bottom right of the display).
The display then shows ENTER PIN (Personal Identifi cation Number) in the top line.
ENTER PIN
12:00 am
The default PIN is 0000, you'll fi nd out later (page 24) how you can change this, but for
now press 0000 on the keypad (under the lid to the bottom right of the display). This clears
the top line and shows * for each number entered.
****
12:00 am
This takes you to the fi rst level of the menu at step 1. This is the INSTALLATION level. The
display looks like this:
1. INSTALL
Press an up or down menu button until you reach the OPTIONS menu, and then press OK
to go to the screen below (or press 7 to go into the OPTIONS menu ):
7. OPTIONS
Press an up or down Menu button to select the desired sub-menu:
CHIME 1. CHIME ON
2. CHIME OFF (No chimes when doors/windows are opened)
SIREN 1. SIREN ON
2. SIREN OFF (Silent Alarm)
HOUSECODE (Chosen by Menu up/down buttons)
LIGHTCODE (Chosen by Menu up/down buttons)
Select the desired sub-menu item and then press OK. Press 1 or 2 in CHIME and SIREN
sub-menus. Select the desired Housecode letter, or desired Security Light Code, using
the up/down buttons. Press OK. Press Clear to back out of the menu. You are asked
to confi rm, 1. YES, 2 NO. Pressing 1 takes you back to the HOME CONTROL screen.
Pressing 2 stays in INSTALL mode.
26
Installation
Setting Delays
Press either of the Menu up/down buttons (under the lid to the bottom right of the display).
The display then shows ENTER PIN (Personal Identifi cation Number) in the top line.
ENTER PIN
12:00 am
The default PIN is 0000, you'll fi nd out later (page 24) how you can change this, but for
now press 0000 on the keypad (under the lid to the bottom right of the display). This clears
the top line and shows * for each number entered.
****
12:00 am
This takes you to the fi rst level of the menu at step 1. This is the INSTALLATION level. The
display looks like this:
1. INSTALL
Press an up or down menu button until you reach the DELAYS menu, and then press OK
to go to the screen below (or press 8 to go into the DELAYS menu ):
8. DELAYS
Press the up or down Menu button to select the desired sub-menu:
ENTRY DELAY (Default 30 seconds)
EXIT DELAY (Default 60 seconds)
DIAL DELAY (Default 5 seconds)
ANSWER DELAY (Default 30 seconds)
Select the desired sub-menu item and then press OK. Then enter the desired delay time in
seconds up to 99. Press OK.
Press Clear to back out of the menu. You are asked to confi rm, 1. YES, 2 NO. Pressing
1 takes you back to the HOME CONTROL screen. Pressing 2 stays in INSTALL mode.
Pressing Clear while entering a number (for a delay time) just clears the numbers.
27