Other X10 Products; Setting Up The Dialer; Programming Phone Numbers - X10 PA5800 Owner's Manual

Installation

Other X10 products

Modules
A wide range of switch and control modules are available from X10, all of which work
together with the Personal Assistance System. Modules available include replacement
wall switches, X10 controlled AC outlets, screw-in lamp modules, plug-in appliance
modules and many others.
Remotes
As well as being able to add up to 16 Pendant Remotes to the system, it is also possible
to add any number of Home Automation wireless remotes such as wireless stick-on wall
switches, keychain remotes, or the PalmPad™ Home Automation remote which controls
up to 16 modules around the house.
Controllers
A range of plug-in controls are available including the Mini Timer which can control up to
four modules with two on/off times each day, the Telephone Responder which allows the
owner to use any touch tone telephone to call home and control X10 modules, and
products which allow any PC to control X10 modules.
Please visit www.x10.com for more information.
1
2
3
4
5
6
7
8
. .
A
. O C .
. .
M E
. . 1 -8
K G
I
1 A
13 5 M E
9 I
Remote Switch
10

Setting up the Dialer

Programming Phone Numbers

Note: you should program the console to call a friend, relative or neighbor who can then
listen-in to your home to determine if there is a real problem. The person can then call
ON OF F
the appropriate emergency services if necessary, or call you back to see if everything is
fine. You should NOT program the console to dial the police or other emergency services
directly.
1. Set the console to INSTALL.
2. Press PROG button.
3. Enter the first phone number that you want the console to call in the event of a
9 -16 problem.
4. Press the MEM button.
5. Press 1 to store the phone number in memory location 1.
Press PROG, enter second phone number, press MEM, 2.
Press PROG, enter third phone number, press MEM, 3.
Press PROG, enter fourth phone number, press MEM, 4.
Repeat the above process to change a phone number.
Note: if you only want to program one phone number, you should store this number in
all four memory locations.
Storing a Voice Message
1. Set the console to INSTALL.
2. Press the RECORD button.
The BUSY light turns on.
3. Speak clearly into the microphone on the front of the console. You can record up to
15 seconds of speech. For example: "There is a burglary in progress at (address).
Press 0 to listen-in."
After 15 seconds the BUSY light turns off.
4. Plug the earphone into the jack on the side of the console.
5. Set console to RUN. The console plays back your message through the earphone so
you can hear what it sounds like (it sounds better when played back over the phone
line).
6. If you want to hear the message again, set console to INSTALL then back to RUN.
Repeat above steps to change the message.
11