X10 SC1200 Owner's Manual page 12

Installation
Recording your outgoing phone message
Press either of the Menu up/down buttons (under the lid to the bottom right of the display).
The display then shows ENTER PIN (Personal Identifi cation Number) in the top line.
ENTER PIN
12:00 am
The default PIN is 0000, you'll fi nd out later (page 24) how you can change this, but for
now press 0000 on the keypad (under the lid to the bottom right of the display). This clears
the top line and shows * for each number entered.
****
12:00 am
This takes you to the fi rst level of the menu at step 1. This is the INSTALLATION level. The
display looks like this:
1. INSTALL
Press an up or down menu button until you reach the MESSAGE menu, and then press
OK to go to the screen below (or press 4 to go into the MESSAGE menu ):
4. MESSAGE
Press 1 or 2 to select one of the options below:
1. RECORD
2. REPLAY
1. RECORD (This is your own alarm message).
2. REPLAY (This replays a previously recorded message).
22
Installation
Press 1 for RECORD , then press OK. The display shows:
PLEASE WAIT
Then:
SPEAK NOW
Clearly speak your message into the Console's microphone (up to 12 seconds max.).
A typical message could be: "There's an alarm in progress at (your address), at the end of
this message please press any button on your touch-tone phone to listen in." After you've
fi nished speaking (12 seconds max), wait for the display shown below:
1. RECORD
2. REPLAY
Now press 2 for REPLAY the display shows:
PLEASE WAIT
It then plays back your recorded message. Wait for the display shown below:
1. RECORD
2. REPLAY
Press Clear to back out of the menu. You are asked to confi rm, 1. YES, 2 NO. Pressing 1
takes you back to the HOME CONTROL screen. Pressing 2 stays in the INSTALL mode.
Note: you cannot record messages remotely via telephone.
23