Switching The Display; Adjusting The Brightness Of The Front Display; Using The Sleep Time (Remote Controller Only); Temporarily Changing The Speaker Output Levels - Integra DTR-8.2 Instruction Manual

Enjoying music or videos with the DTR-8.2
Standby/On
Standby
Power
On O f f
Direct/ Zone 2 ( GRN )
Pure Audio
Rec ( RED )
Audio
DVD Video 1
Selector
Pure Audio U psampling
Phones
Zone 2 Level Rec Out Zone 2 Off Stereo Surround
When using the remote controller, select AV Amp in the Home menu to
display the operation menu. Then tap the down scroll button twice to
display the third operation menu (Dim, Sleep, CH Sel, and +/–) or tap
the down scroll button to display the next operation menu (Display).

Switching the display

While listening to or watching an input source, you can display the
information regarding the type of source and signal being input by
pressing the Display button on the DTR-8.2 or the remote controller.
DTR-8.2
Display
When an input source other than FM or AM is selected:
Input + volume
Program format*
Input +
Listening mode
or Multi Ch
* If the input signal does not have a program format, then this will
be skipped.
When FM or AM is selected as the input source:
FM/AM frequency +
Preset no.
FM/AM +
Listening mode

Adjusting the brightness of the front display

You can adjust the brightness of the front display of the DTR-8.2
with the Dim button on the remote controller or the Dimmer button
on the DTR-8.2 front panel.
DTR-8.2
Dimmer
Input source buttons
Master Volume
Video 2 Video 3 Video 4 Video 5 Tape FM AM Phono CD
Display
Video 5 /Video Cam Input
THX DSP Dimmer FM Mode Memory Setup Tuning Enter Preset Return
Clear
Didital S Video Video L Audio R
Dimmer
Remote controller
ch
Remote controller
–
CONT
+
LIGHT
Dim
Sleep
Display

Using the sleep time (remote controller only)

The Sleep button enables you to set the DTR-8.2 to turn off
automatically after a specified time period. If you press it once, the
DTR-8.2 will turn off after 90 minutes. Each time it is pressed
thereafter, the remaining time until the DTR-8.2 turns off decreases
by 10 minutes. While, the sleep function is enabled, you can press
the Sleep button to see how much time is left. To cancel the sleep
function, press the Sleep button when the time displayed is less than
10 minutes.
If you are using the remote zone (Zone 2), it will turn off at the same
time as the main zone. If you want to set the sleep function for Zone
2 only, set the sleep function with main zone turned on and then put
the main zone into the standby state.

Temporarily changing the speaker output levels

To change the individual speaker volumes temporarily, follow the
procedure given below. Each channel can be set between –12 to +12
decibels. Note that the calibration settings will return to the original
settings when the DTR-8.2 is put in standby.
1. Press the CH Sel button and select
the desired speaker.
2. Press the + or – button to adjust the
volume level.
Notes:
• You cannot select a speaker if the Speaker Config sub-menu of
the Speaker Setup is set to No or None.
• If the speaker level is set to +1 dB or higher, the maximum level
indicated on the display will change if you raise the volume
level.
• When you press the Test button after you set the level, the
current level will be used as the value set via the test tone.
MUTE
+
CH
–
+ / –
VOL
CH Sel
Remote controller
53