Ryobi P551 Operator's Manual page 17

socket head
screw(s)
Miter
fence
SqUARING THE bLAdE TO THE FENCE
See Figures 16 - 19.
 Remove the battery pack from the tool.
 Pull the saw arm all the way down and engage the lock
pin to hold the saw arm in transport position.
 Lift the miter lock lever.
 Rotate the miter table until the pointer aligns with zero
on the miter scale.
 Push the miter lock lever down to lock the miter table.
 Lay a square flat on the miter table. Place one leg of the
square against the fence. Slide the other leg of the square
against the flat part of saw blade.
NOTE: Make sure that the square contacts the flat part
of the saw blade, not the blade teeth.
 The edge of the square and the saw blade should be
parallel as shown in figure 17.
 If the front or back edge of the saw blade angles away
from the square as shown in figures 18 and 19, adjust-
ments are needed.
 Using the blade wrench, loosen the socket head screws
that secure the miter fence to the miter table. See figure
16.
 Rotate the miter fence left or right until the saw blade is
parallel with the square.
 Retighten the screws securely and recheck the blade-to-
fence alignment.
The saw has two scale indicators, one on the bevel scale
and one on the miter scale. After squaring adjustments have
been made, it may be necessary to loosen the indicator
screws and reset them to zero.
ASSEMbLy
socket head
screw(s)
Miter
Lock
Lever
Fig. 16
Miter
fence
view of bLade square with fence
Miter
fence
view of bLade not square with fence, adJustMents
Miter
fence
view of bLade not square with fence, adJustMents
17
fraMing
Miter
square
tabLe
fraMing
Miter
square
tabLe
are required
fraMing
Miter
square
tabLe
are required
bLade
Fig. 17
bLade
Fig. 18
bLade
Fig. 19