Lenovo ThinkServer RD240 User Manual page 92

(english) installation and user guide
Hide thumbs Also See for ThinkServer RD240:
Table of Contents

Advertisement

Table 17. Submenus under the Hardware Health Configuration
Item
Items and options with BMC configuration:
Auto Fan Control
PWM Minimal Duty Cycle
Sensor Data Register Monitoring
Items and options without BMC configuration:
H/W Health Function
Auto FAN Control
PWM Minimal Duty Cycle
Fan Failure LED Indication
Hardware Health Event Monitoring
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 18. Submenus under the IPMI 2.0 Configuration
Item
View BMC System Event
Log
Clear BMC System Event
Log
Set LAN Configuration
Set PEF Configuration
80
ThinkServer User Guide
Option
Disabled / [Enabled]
[60% Duty Cycle] / 45% Duty Cycle
/ 30% Duty Cycle
Read Only
Disabled / [Enabled]
Disabled / [Enabled]
[60% Duty Cycle] / 45% Duty Cycle
/ 30% Duty Cycle
Disabled / [Enabled]
Read Only
Sub-item
PEF SUPPORT
If this option is set to Disabled, the
fan runs at the full speed; if this option
is set to Enabled, the fan speed is
controlled by the system temperature.
Select the PWM Minimal Duty Cycle
for the fan: 60%-100%, 45%-100%,
or 30%-100%.
The sensor data in this option is for
read only. The detected data includes
the temperature, voltage and fan
speed.
Enable or disable the hardware
monitor function.
If this option is set to Disabled, the
fan runs at the full speed; if this option
is set to Enabled, the fan speed is
controlled by the system temperature.
Select the PWM Minimal Duty Cycle
for the fan: 60%-100%, 45%-100%,
or 30%-100%.
Enable or disable the fan alarm
function. If this option is set to
Enabled, a message about fan failure
will be displayed on the POST screen
when the rotational speed of each fan
is less than 800 rpm.
The sensor data in this option is for
read only. The detected data includes
the temperature and system fan
rotational speed.
Option
Disabled / [Enabled]
Description
Description
View the system event log.
Delete the system event
log.
Set the IP address source,
IP address, subnet mask,
and gateway address.
Enable or disable the PEF
support.

Advertisement

Table of Contents
loading

Table of Contents