Lenovo ThinkServer RD240 User Manual page 29

Figure 6. Locating other connectors on the system board
1
System fan 1 connector
2
System fan 2 connector
3
System fan 3 connector
4
System fan 4 connector
5
Front USB connector
6
J51 (SGPIO connector for onboard
SAS port 1-4)
The following table introduces the jumper switches on the system board.
Table 6. Jumper settings
Jumper Position
JP1: Clear Pins 1-2
CMOS
Pins 2-3
Pins 1-2
JP7: Set
Onboard
SAS
Pins 2-3
Note: Before clearing the CMOS, turn off the server and disconnect the power cord. Move the jumper from
pins 1-2 to pins 2-3. Wait more than five minutes and then move the jumper back to the normal position
(pins 1-2) to clear CMOS.
7
J35 (for front control cable)
8
JP1 (clear CMOS)
9
USB 2 connector
10
J21 (SGPIO connector for onboard SAS port 5-8)
11
JP7 (set onboard SAS)
12
J16 (COM2 connector)
The default position at which the jumper is placed on pins 1-2 during the normal
operation of the system.
If the jumper is placed on pins 2-3, when the jumper is moved back to the default
position, the settings of CMOS will be cleared automatically at the next startup.
The default position at which the jumper is placed on pins 1-2 during the normal
operation of the system. The onboard SAS controller is enabled.
If the jumper is placed on pins 2-3, the onboard SAS controller is disabled.
Description
.
Chapter 4 Locating parts, controls, LEDs, and connectors
17