Epson Dreamino EMP-TW20 User Manual page 41

The remote control does not work
Is the remote control light-
emitting area facing towards
the remote control light-
receiving area when it is
operated?
Is the remote control too far
from the projector?
Is direct sunlight or strong
light from fluorescent lamps
shining onto the remote
control light-receiving area?
Are the batteries dead, or have
the batteries been inserted
correctly?
Has a remote control button
been pressed for more than 30
seconds?
Face the remote control towards the remote control light-receiving
area.
The operating angle for the remote control is approximately ±30°
horizontally and approximately ±15° vertically.
The operating range for the remote control is approximately 6m.
p.13
Set the projector up in a location where strong light will not shine
onto the remote control light-receiving area.
Insert new batteries, while making sure that they face correctly.
p.13
If any of the buttons on the remote control are pressed down for
more than 30 seconds, the remote control stops sending signals
(remote control's sleep mode) . The purpose of this is to prevent the
batteries from being consumed due to something being placed on top
of the remote control. When the button is released, normal remote
control operation will resume.
Problem Solving
p.13
39