Epson Dreamino EMP-TW20 User Manual page 30

Configuration Menu Functions
Zoom Caption *
If "Aspect " is set to "Zoom" when viewing images with subtitles, change the setting as follows so that
the subtitles are visible. The vertical size and the display position can both be adjusted together.
•
Vertical Size
The vertical size of the image is
reduced so that the subtitles are
displayed.
•
Zoom Position
The whole of the image is moved
up so that the subtitles are dis-
played.
Output Scaling *
During input of component video or RGB-video signals only, this permits alteration of the output scaling
(extent of the image projected).
Normal (92% display) :Input signals are projected at the normal image size. TV images are displayed at
Larger :Component video and RGB-video images are displayed at 100% size.
Keystone
This is used to correct keystone distortion in images. The same correction can be carried out using the
projector's control panel.
Projection
This should be set in accordance with the method used to set up the projector.
•
Front
•
Front/Ceiling : Select when the projector is set up in front of the screen and suspended from a ceiling.
•
Rear
•
Rear/Ceiling : Select when the projector is set up behind the screen and suspended from a ceiling.
Setup Level *
(This can only be set when NTSC
525i/525p component video signals are being input.)
If using products designed for destinations such as South Korea that have different black level (setup
level) settings, use this function to obtain correct images. Check the specifications of the connected
equipment when changing this setting.
Operation
Direct Power ON
Sets whether "Direct Power ON" is enabled ("ON") or disabled ("OFF").
When you set to "ON" and leave the power cable connected to a wall socket, be aware of that sudden
surges of electricity that may occur when power comes back on after a power outage may cause the
projector to turn on automatically.
28
1
1
92% size.
The areas at the top, bottom and sides of images that cannot normally be seen are inserted and pro-
jected. Interference may occur at the top, bottom and sides of the images depending on the image
signal. In such cases, try to adjust the display position.
p.17
: Select when the projector is set up in front of the screen.
: Select when the projector is set up behind the screen.
1
*1 The setting values are stored separately for each image source and signal type.
Projection area
Subtitle section
signals from composite video or S-Video are being input or when
Use "Vertical Size" to
reduce the image size.
Use "Zoom Position" to
change the display position
of the image.
p.27