Video Input; Selecting Input Source - Eiki LC-X71 Owner's Manual

VIDEO INPUT

DIRECT OPERATION
Select an INPUT source by pressing the INPUT button on
the top control or the INPUT 1, INPUT 2, or INPUT 3 buttons
on the remote control.
If the projector cannot reproduce proper image, select a
correct input source through MENU OPERATION (see
below).
MENU OPERATION
When connecting to video equipment, select a type of Video
source in the Source Select Menu.
1
Press the MENU button to display the On-Screen Menu.
Press the POINT LEFT/RIGHT buttons to move the red frame
pointer to the INPUT Menu icon.
2 Press the POINT UP/DOWN buttons to move the red arrow
pointer to Input 2 and then press the SELECT button. A
Source Select Menu appears.
3
Move the pointer to a source that you want to select and then
press the SELECT button.
When the video input signal is connected to the
Video
VIDEO jack, select Video.
When the video input signal is connected to the Y-
Y, Pb/Cb, Pr/Cr
Pb/Cb-Pr/Cr jacks, select Y, Pb/Cb, Pr/Cr.
NOTE:
• INPUT SOURCE changes if the INPUT 2 button on the remote control is
pressed.
When connecting to video equipment, select a type of Video
source in the Source Select (Video) Menu.
1 Press the MENU button to display the On-Screen Menu.
Press the POINT LEFT/RIGHT buttons to move the red frame
pointer to the INPUT Menu icon.
2
Press the POINT UP/DOWN buttons to move the red arrow
pointer to Input 3 and then press the SELECT button. A
Source Select Menu appears.
3 Move the pointer to a source that you want to select and then
press the SELECT button.
When the video input signal is connected to the
Video
VIDEO jack, select Video.
When the video input signal is connected to the Y-
Y, Pb/Cb, Pr/Cr
Pb/Cb-Pr/Cr jacks, select Y, Pb/Cb, Pr/Cr.
When the video input signal is connected to the S-
S-Video
VIDEO jack, select S-Video.
NOTE:
• INPUT SOURCE changes if the INPUT 3 button on the remote control is
pressed.

SELECTING INPUT SOURCE

WHEN SELECTING INPUT 2 (5 BNC INPUT JACKS )
WHEN SELECTING INPUT 3 (AV TERMINALS )
INPUT button
Input 1
Input 2
Input 3
✽ Input 1 is not displayed when the Input 1 is used as
Monitor out.
INPUT MENU
INPUT Menu icon
Move the pointer (red arrow) to Input 2
and press the SELECT button.
Input 2
Source Select Menu
Move the pointer (red arrow)
to Video or Y, Pb/Cb, Pr/Cr
and press the SELECT
button.
INPUT MENU
INPUT Menu icon
Move the pointer (red arrow) to Input 3
and press the SELECT button.
Input 3
Source Select Menu
Move the pointer (red arrow)
to a source and press the
SELECT button.
31