Mass Storage Device Guide Rails - HP Workstation x2000 Supplementary Manual

Mass Storage Device Guide Rails

Extra guide rails are attached to the side of the front access cage for
additional mass storage device installations. Depending on the device to
be installed, dedicated guide rails are required and are easily recognized
by their distinct size and color.
The following table indicates the device, location, and required rails.
Device to be Location
Installed
3.5-inch device 3.5-inch
(hard disk drive) internal
shelf (two
shelves)
5.25-inch device 5.25-inch
(CD-ROM, etc.) front access
cage shelf
3.5-inch device
(floppy, zip drive,
etc.)
Chapter 1
HP x2000 Service Information
Mass Storage Device Guide Rails
Required Installing the Rails
Rails
Narrow blue Insert the guide rail labeled
left and right "L" on the left-hand side
rails (cable connectors facing
towards you and positioned
at the bottom), and the guide
rail "R" on the right-hand
side of the hard disk drive.
Wide green There is no specific side to
rails which these guides must be
installed. However, they
must be inserted in the two
holes located at the bottom
of the drive.
Narrow Carefully break off the metal
green left plate from the chassis.
and right Insert the guide rail labeled
rails "L" on the left-hand side
(cable connectors facing
towards you and positioned
at the top), and the guide
rail "R" on the right-hand
side of the hard disk drive.
13