Advertisement
CH-500/CHS-520
Insert the side columns into the base. At this time,
make sure that the damper rest, attached at the
center of the column, and the short section of the
column is positioned upright.
Damper Rest
6
Short Section
Side Column
Long Section
ASSEMBLY PROCEDURE
Fit the damper onto the side columns and lower
the damper onto the damper rest. Next, secure
the damper in its position with the damper wing
bolts. At this time, tighten the wing bolts that se-
cure the side column to the base as well.
Damper
Base
Remove the damper stay, attached to the bottom
of the damper, loosen the wing bolt on the damper
stay, and attach the stay to the pedal hook. The
pedal's position can be controlled by adjusting the
length of the pedal stay with its two wing bolts. At
this time, tighten the upper wing bolt first, then go
on to tighten the lower bolt.
Adjust the pedal position so that the pedal stops
slightly above the floor when fully depressed.
Damper Stay
Side Column
Damper Rest
Damper Stay
Pedal Hook
Base
Advertisement
