Main Menu; Primary Ide Master/Slave; Sata 1-5; Esata - Asus M4A78-E - Motherboard - ATX User Manual

3.4

Main menu

When you enter the BIOS Setup program, the Main menu screen appears, giving you an
overview of the basic system information. You can set the system time and date, BIOS
language, and the type of floppy drive installed.
Refer to 3.3.1 BIOS menu screen for information on the menu screen items and how to
navigate through them.
Main Ai Tweaker Advanced Power Boot Tools Exit
System Time
System Date
Legacy Diskette A
Primary IDE Master
Primary IDE Slave
SATA1
SATA2
SATA3
SATA4
SATA5
ESATA
Storage Configuration
System Information
v02.61 (C)Copyright 1985-2008, American Megatrends, Inc.
3.4.1 Primary IDE Master/Slave; SATA 1–5; ESATA Primary IDE Master/Slave; SATA 1–5; ESATA
While entering Setup, the BIOS automatically detects the presence of IDE/SATA devices.
There is a separate submenu for each IDE/SATA device. Select a device item then press
<Enter> to display the SATA device information.
Main
SATA 1
Device : Hard Disk
Vendor : HDT722516DLA380
Size : 164.7GB
LBA Mode : Supported
Block Mode : 16Sectors
PIO Mode : 4
Async DMA : MultiWord DMA-2
Ultra DMA : Ultra DMA-6
SMART Monitoring:Supported
LBA/Large Mode
Block(Multi-sector Transfer)M [ Auto]
PIO Mode
DMA Mode
SMART Monitoring
32Bit Data Transfer
v02.61 (C)Copyright 1985-2008, American Megatrends, Inc.
The BIOS automatically detects the values opposite the dimmed items (Device, Vendor, Size,
LBA Mode, Block Mode, PIO Mode, Async DMA, Ultra DMA, and SMART monitoring). These
values are not user-configurable. These items show N/A if no IDE device is installed in the
system.
ASUS M4A78-E
BIOS SETUP UTILITY
[13:51:25]
[Tue 12/09/2008]
[1.44M, 3.5 in.]
[Not Detected]
[Not Detected]
[HDT722516DLA380]
[Not Detected]
[ATAPI DVD DH1]
[Not Detected]
[Not Detected]
[Not Detected]
SATA 1–5; ESATA
BIOS SETUP UTILITY
[Auto]
[Auto]
[Auto]
[Auto]
[Enabled]
Use [ENTER], [TAB]
or [SHIFT-TAB] to
select a field.
Use [+] or [-] to
configure system Date.
←→ Select Screen
↑↓ Select Item
+- Change Field
Tab Select Field
F1 General Help
F10 Save and Exit
ESC Exit
Select the type
of device connected
to the system.
←→ Select Screen
↑↓ Select Item
+- Change Field
F1 General Help
F10 Save and Exit
ESC Exit
3-9