If you want to use an existing fan site, complete the following checklist to System determine if the site is acceptable and safe for your new Hunter fan . If you cannot check off every item, prepare a new fan site as described on this page .
Page 4
ANSI/NFPA 70 . If your ceiling fan, go to your fan manual and continue with Section 2 • Installing the you are unfamiliar with wiring, use a Ceiling Plate. qualified electrician . 42693-01 • 05/14/10 • Hunter Fan Company...
Page 5
Support Brace Hunter’s patented 3-position mounting system provides you maximum installation flexibility and ease . You can install your Hunter fan in one of three ways, depending on ceiling height and your preference: Low Profile, Standard, or Angled mounting . The steps in this manual include Ceiling instructions for all three Installer’s Choice mounting methods .
Parts Guide . Check for any shipping damage to the motor blade irons (if applicable) in sets, or fan blades . If any parts are missing or damaged, contact your Hunter as they were shipped . dealer or call Hunter Technical Support Department at 888-830-1326 (In Canada, call 1-866-268-1936) .
. Tighten the screws into the 9/64” pilot holes; do not use lubricants on the screws . Do not over tighten . Ceiling Plate Flat Washer 3” Wood Steps 2-3 – 2-6 Screw 42693-01 • 05/14/10 • Hunter Fan Company...
3-7 . Raise the fan and align the slots in the canopy with the hooks on the ceiling plate . Low Profile Washer 3-8 . Place the slots over the hooks to hang the fan . 42693-01 • 05/14/10 • Hunter Fan Company...
. 4-7 . Run the white antenna wire from the receiver around the inside of the canopy for clear reception . Large Wire Small Wire Connector Connector 42693-01 • 05/14/10 • Hunter Fan Company...
CAUTION: The remote control device complies with part 15 of 1 = on (encendido) on (encendido) the FCC rules . Changes or modifications not expressly approved by Hunter Fan Company could void your authority to operate this equipment . Operation is subject to the following two conditions: Remote Transmitter 1 .
Note: Should you need to remove the trim ring, press firmly on Canopy opposite sides of the trim ring directly above the groove in the Trim hanger ball . The tabs will flex out releasing the canopy trim ring . Ring Canopy Screw 42693-01 • 05/14/10 • Hunter Fan Company...
7 • Assembling the Blades Step 7-1 (Detail) Hunter fans use several styles of fan blade irons (brackets that hold the blade to the fan) . 7-1 . Your fan may include blade grommets . If your fan has grommets, insert them by hand into the holes on the blades .
8 • Completing Your Installation With or Without a Bowl Light Fixture Your Hunter fan comes with an integrated light fixture assembly and an optional switch housing cap and plug button . This feature gives you the option of installing the fan with OR without the included light fixture .
Page 14
Exceeding the wattage limit marked on the MAX wattage sticker affixed to the light socket(s) may result in fire hazard or improper operation . If lights do not appear to be operating properly, see the troubleshooting section . Housing Assembly Screw 42693-01 • 05/14/10 • Hunter Fan Company...
Page 15
. (You may find the Light Bulbs breakaway connector on the (B10 Candelabra end of the extra chain . ) Base 60 Watt Maximum) Metal Rod Glass Bowl Cover Plate Breakaway Finial Connector 42693-01 • 05/14/10 • Hunter Fan Company...
Page 16
8-19 . Install the switch housing cap and plug button to the lower switch housing . 8-20 . Once you have uninstalled the light fixture, continue with step 8-6 . Step 8-16 Male Dummy Terminal Female Dummy Terminal Plug Button Step 8-19 42693-01 • 05/14/10 • Hunter Fan Company...
. 9-6 . The blades on this fan have been treated with Hunter’s Dust Armor protection, making the blades less likely to attract dust and dirt . Use a dry or slightly damp lint free cloth to clean the blades .
10-3 . Use the Fan buttons to turn the Fan On and Off . Fan Off Fan On 10-4 . When necessary, replace the battery with a 12-volt type 23A, MN-21 battery or equivalent . Light Off Light On Steps 10-2 – 10-3 Step 10-4 42693-01 • 05/14/10 • Hunter Fan Company...
888-830-1326 (In Canada, call 1-866-268-1936) or visit us at our Web site at http://www . h unterfan . c om . Hunter Fan Company 7130 Goodlett Farms Pkwy . #400 Memphis, Tennessee 38016 42693-01 • 05/14/10 • Hunter Fan Company...
Need help?
Do you have a question about the 23949 and is the answer not in the manual?
Questions and answers