Assembling The Fan - Hunter 23781 Owner's Manual And Installation Manual

Standard or Angle Mounting
Steps 3-2 – 3-3
Set Screw
Low Profile Mounting
Steps 3-5 – 3-6
Green
Ground
Wire
Canopy
Trim Ring
Low Profile Screw
3 • Assembling the Fan
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
3-1. Unbundle the wires from the fan.
For Standard or Angle mounting:
Downrod
3-2. Insert the downrod through the canopy and canopy trim ring.
Feed the wires from the fan through the downrod on one side of
the pin in the ball.
3-3. Loosen the square head set screw on the adapter to install the
Canopy
pipe and ball assembly. Note: When the pipe and ball assembly
is fully installed, 2-3 threads on the pipe will still be visible; this is
Canopy normal. Securely retighten the set screw with a wrench or pliers.
Trim Ring
Go to 4 • Hanging and Wiring the Fan.
CAUTION: The adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
For Low Profile mounting:
Note: For low profile mounting, the downrod is replaced with the
low profile washer.
Low Profile
3-4. Remove the set screw from the adapter.
Screws
3-5. Place the low profile washer into the canopy with the lip down.
Low Profile
Washer
3-6. Align the holes in the washer with the holes in the adapter.
Assemble securely with three low profile screws.
Go to 4 • Hanging and Wiring the Fan.
Step 3-6 (Detail)
Canopy
8
42609-01 • 01/12/11 • Hunter Fan Company
Adapter
Low Profile Screw
Low Profile
Washer