Hanging And Wiring The Fan - Hunter 23781 Owner's Manual And Installation Manual

4-1. Raise the fan and align the slots in the canopy with the hooks on the
ceiling plate.
Note: To hang the fan, you must tilt the canopy to an almost vertical
position so that the canopy slots sit on the ceiling plate hooks.
All wiring must be in accordance with national and local electrical
codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a
qualified electrician.
Wall switches are not included. Select an acceptable general-use switch in
accordance with national and local electrical codes.
4-2. Make sure the power to the outlet box and associated wall switch
location is still OFF.
To connect the wires, hold the bare metal leads together and place a
wire connector over them, then twist the wire connector clockwise
until tight.
CAUTION: Be sure no bare wire or wire strands are visible after
making connections.
Connect the bare or green ground wire (grounding) from the ceiling
to the green ground wire (grounding) from the ceiling plate and the
green ground wire from the fan or the green ground wire present on
the low profile washer.
Single Switch Wiring:
If you want to, you can control both fan and light with one switch. To
do so connect the wires as follows:
• The white wire from the ceiling to the white wire from the fan
• The black wire from the ceiling to the black and the black/white
wire from the fan
Dual Switch Wiring:
• The white wire from the ceiling to the white wire from the fan
• The black wire from the ceiling to the black wire from the fan
• The black/white wire from the fan to the wire for the wall switch
4-3. Push all wires and wire connectors into the outlet box.
4 • Hanging and Wiring the Fan
9
42609-01 • 01/12/11 • Hunter Fan Company
Wire
Connector
Single Switch Wiring
Dual Switch Wiring