I Clamping The Power Plug And Power Cord - Panasonic WXC3010 - CENTER MODULE - MULTI LANGUAGE Operating Instructions Manual

I Clamping the Power Plug and
Power Cord
Important:
Surely clamp the power plug to this center module and
screw the AC cable to the wall using the provided AC
cable clamper.
1. Insert an AC cable holder into the hole under the AC
inlet.
AC cable holder
2. Slide the holder to the backward by pushing down the
clamp lever.
Slide the holder
to the backward
by pushing down
the lever.
G Refer to the following lists attached on the inside of the terminal cover to make connections.
CONNECTOR 1
ORDER INTERFACE
CONNECTOR 2 CONNECTOR 3
ORDER INTERFACE POS INTERFACE
3. Insert the power plug into the power cord inlet.
4. Push the holder forward until the holder touches the
power plug.
2
3
5. Lock the holder.
6. Clamp the AC cable with the provided clamp, and
secure the AC cable clamper to the wall by fastening the
screws.
150 mm - 200 mm
{5-15/16" - 7-7/8"}
AC cable clamper
CONNECTOR 4 CONNECTOR 5
POS INTERFACE
CONNECTOR 6 CONNECTOR 7
MAINTENANCE DDT INTERFACE
21