Using electronic view finder (sold separately)
If you use the electronic view finder (sold separately: VF-2), you can view the
shooting screen in the finder. This is convenient when you are in a very bright
location, such as under direct sunlight, where it is difficult to view the monitor,
or are using the camera at a low angle. Also refer to the electronic view finder's
manual.
1
Turn off the camera.
2
Slide off the hot shoe cover.
•
Keep the shoe cover in a safe place to
avoid losing it.
3
Remove the connector cover from
the electronic view finder.
4
Align the electronic view finder with the hot shoe on the camera
body, and slide it in until it stops.
•
Insert the electronic view finder by pushing on its lower part.
5
Turn on the camera.
6
Each press of the u button switches between the monitor
display and electronic view finder display.
You can adjust the brightness and color temperature of the electronic view
•
finder. g "EVF ADJUST" (P. 74)
7
Turn the diopter adjustment ring to
a position where the image on the
viewfinder can be seen clearly.
11
•
Adjust the electronic view finder to your
preferred angle (up to 90 degrees).
#
Caution
•
You cannot use an external flash and the electronic
view finder at the same time.
•
When carrying the camera, do not hold it by the
electronic view finder. The camera may separate
from the electronic view finder and drop.
•
Do not leave the camera with the electronic view
finder attached in a location subject to direct
sunlight.
10 EN