Table of Contents
Advertisement
Specifying Flash Intensity (Flash Intensity)
Procedure
[r] (REC) * [MENU] * Quality Tab * Flash Intensity
You can specify one of 13 flash intensity settings, from –2.0 EV (weakest) to +2.0 EV
(strongest).
• Flash intensity may not change when the subject is too far away or too close.
Turning On Flash Assist (Flash Assist)
Procedure
[r] (REC) * [MENU] * Quality Tab * Flash Assist
The subject in an image will look
too dark if flash intensity is not
enough to reach a subject that is
too far away. When this happens,
you can use flash assist to
supplement the brightness of the
subject so it appears as if flash
illumination was sufficient. Select
"Auto" to turn on Flash Assist.
Flash Assist may not produce the
desired result if you use it after changing the initial default settings of any of the
following.
Flash Intensity, EV Shift, ISO, Contrast
Using Built-in Color Filters (Color Filter)
Procedure
[r] (REC) * [MENU] * Quality Tab * Color Filter
Settings: Off, B/W, Sepia, Red, Green, Blue, Yellow, Pink, and Purple
Flash assist turned off
89
Flash assist turned on
Advanced Settings
Advertisement
Table of Contents
