Table of Contents
Advertisement
Chapter 3 - Configuration
Enable DHCP Server - Click this to allow the Vonage VWR Device to assign your
computers the IP settings automatically.
Start IP - Enter the starting address for the DHCP server's IP assignment.
End IP - Enter the ending IP address for the DHCP server's IP assignment.
Note: If you statically (manually) assign IP addresses to your computers or
devices, make sure the IP addresses are outside of this range or you may have
an IP conflict.
Lease Time - The length of time for the IP address lease. Enter the Lease time in
seconds.
Enable DHCP Relay - Select this option to enable DHCP Relay. When DHCP relay is
enabled, the Vonage VWR Device is responsible for forwarding DHCP requests and
responses between network clients and a specified DHCP server.
Relay IP - Enter the IP address of the DHCP server that client DHCP requests will be
relayed to.
Server and Relay Off - When the DHCP server and relay functions are turned off, the
network administrator must statically configure the IP address, subnet mask and DNS
settings of every host on the network. The same IP address cannot be assigned to more
than one host, and the Vonage VWR Device must reside on the same subnet as the
other hosts.
LAN Clients - If you want a computer or device to always have the same IP address
assigned, you can create a DHCP reservation. The Vonage VWR Device will assign the
IP address only to that computer or device.
Note: This IP address must be within the DHCP IP Address Range.
Enter IP Address - Enter the IP address you want to reserve.
Hostname - Enter a name of the computer.
MAC Address - Enter the MAC address of the computer you want to assign the
IP address to.
If your computer is already listed, simply check the reserve box and click Apply.
D-Link VWR User Manual
13
Advertisement
Table of Contents
