Formatting The Storage Card; Write-Protecting The Storage Card - Newton QuickTake 200 Camera Getting Started

Formatting the storage card

1 Turn on the camera by sliding the power switch (
direction indicated by the arrow and then releasing it.
2 To format the storage card, turn the mode dial to Erase (
3 Use the plus (+) and minus (–) buttons (next to the mode dial) to select
the screen.
4 Press the action button (next to the + and – buttons).
appears blinking on your screen.
OK?
5 Press the action button again to format the card.
When you format a card, all the data on the card is removed,
WARNING
including any protected images.

Write-protecting the storage card

To prevent erasing important data from your storage card, place a write-
protect seal over the write-protect circle on the card. You receive 4 seals with
every card you buy. (You cannot reuse seals.)
This seal makes it impossible to record data to or erase data from the card.
To again use the card to record or erase data, remove the seal.
Write-protection might not function if the seal becomes dirty. Use
IMPORTANT
a dry, lint-free cloth to wipe the seal clean.
‰
) (above the LCD screen) in the
#
) mode.
Getting Started With the QuickTake 200 Camera
FORMAT on
9