Battery-Saving Mode - Newton QuickTake 200 Camera Getting Started

Battery-saving mode

1
2
3
4
5
6
26
Chapter 2
Note: After you transfer your images to the computer, you can erase all the
images from your camera. However, the images that you have protected are
not erased.
To remove protection
While the camera is in Protect mode, select the protected frame, and press the
action button again. The protection icon disappears and the image is no
longer protected.
To conserve your batteries, you can turn off your LCD screen and still take
pictures using the optical viewfinder.
Attach the optical viewfinder to your camera.
Turn on the camera using the power switch (
In either Record or Record-Fine mode to take pictures, press the action button twice to
put the LCD screen to sleep.
The red sleep light on the front of the camera goes on. You cannot see live,
video images on the LCD screen when you put the screen to sleep.
Use the viewfinder to focus on the image that you want to capture.
Press the shutter release to take a picture.
The LCD screen turns on and captures the image. The image appears on the
screen for about 5 to 8 seconds allowing you to review the picture that you
just captured, and then the screen goes to sleep—ready for you to take
another picture.
Press the shutter release again to take another picture.
Press the action button once to again turn on the LCD screen.
IMPORTANT
‰
).