Displaying And Hiding The Date And Time; What If You Upgrade Your System Software; What's Next - Newton QuickTake 200 Camera Getting Started

6

What if you upgrade your system software?

What's next?

12
Chapter 1
After you set the number for minutes, press the – button again.
The date and time are now set.

Displaying and hiding the date and time

You can display and hide the date and time on your LCD screen when you are
using either Record-Fine or Record mode.
Press the + button to display the date and press again to hide it.
Press the – button to display the time and press again to hide it.
IMPORTANT The date and time remain set for up to 5 minutes while you
change the battery. You must reset the date and time after 5 minutes have
elapsed without batteries in the camera.
If you decide to replace or upgrade your system software after you've installed
the QuickTake software, you might not be able to connect to the camera. You
must reinstall the Apple QuickTake 200 software. See "Installing the
QuickTake Software," earlier in this chapter.
Read Chapter 2 for instructions about how to take pictures with your
QuickTake 200 camera.